Implementation of Resonant and Passive Lossless Snubber Circuits for DC-DC Boost Converter
DOI:
https://doi.org/10.14419/ijet.v7i4.30.22276Keywords:
DC-DC Boost Converter, Passive Lossless Snubber, Resonant, Soft-Switching, Switching FrequencyAbstract
This paper presents the comparison of resonant and passive lossless snubber circuits implementation for DC-DC boost converter to achieve soft-switching condition. By applying high switching frequency, the volume reduction of passive component can be achieved. However, the required of high switching frequency cause the switching loss during turn-ON and turn-OFF condition. In order to reduce the switching loss, soft-switching technique is required in order to reduce or eliminate the losses at switching devices. There are various of soft-switching techniques can be considered, either to reduce the switching loss during turn-ON only, or turn-OFF only, or both. This paper discusses comparative analyses of resonant and passive lossless snubber circuits which applied in the DC-DC boost converter structure. Based on the simulation results, the switching loss is approximately eliminated by applying soft-switching technique compared to the hard-switching technique implementation. The results show that the efficiency of resonant circuit and passive lossless snubber circuit are 82.99% and 99.24%, respectively. Therefore, by applying passive lossless snubber circuit in the DC-DC boost converter, the efficiency of the converter is greatly increased. Due to the existing of an additional capacitor in soft-switching circuit, it realizes lossless operation of DC-DC boost converter.
References
[1] Al Sakka M, “DC/DC Converters for Electric Vehiclesâ€, J. Van Mierlo and S. Soylu, Eds. Rijeka: InTech, (2011), pp. 13.
[2] Kasiran AN, Ponniran A, Harimon MA & Hamzah HH, A Study of 4-level DC-DC Boost Inverter with Passive Component Reduction Consideration, Vol. 995, (2018).
[3] One P & Engines IC, “DC-DC converter for Hybrid Electric Vehicle and EVâ€.
[4] Martinez WH & Cortes CA, “High power density interleaved DC-DC converter for a high performance electric vehicleâ€, in 2013 Workshop on Power Electronics and Power Quality Applications (PEPQA), (2013), pp. 1–6.
[5] Ponniran AB, Orikawa K & Itoh J, “Minimum Flying Capacitor for N-Level Capacitor DC-DC Boost Converterâ€, IEEE Trans. Ind. Appl., Vol. 52, No. 4, (2016), pp. 3255–3266.
[6] Ponniran A, Matsuura K, Orikawa K & Itoh J, Size Reduction of DC-DC Converter using Flying Capacitor Topology with Small Capacitance, Vol. 3, (2014).
[7] Zhu JY & Ding DH, “Zero voltage and zero current switched PWM DC-DC converters using active snubber techniqueâ€, in Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242), Vol. 2, (1998), pp. 1574–1579.
[8] Kishore KVR, Wang BF, Kumar KN & So PL, “A new ZVS full-bridge DC-DC converter for battery charging with reduced losses over full-load rangeâ€, in 2015 Annual IEEE India Conference (INDICON), (2015), pp. 1–6.
[9] Marshall J & Kazerani M, “A Novel Lossless Snubber for Boost Convertersâ€, in 2006 IEEE International Symposium on Industrial Electronics, Vol. 2, (2006), pp. 1030–1035.
[10] Tseng CJ & Chen CL, “A passive lossless snubber cell for nonisolated PWM DC/DC convertersâ€, IEEE Trans. Ind. Electron., Vol. 45, No. 4, (1998), pp. 593–601.
[11] Kazimierczuk MK, “Design-oriented analysis of boost zero-voltage-switching resonant DC/DC converterâ€, IEEE Trans. Power Electron., Vol. 3, No. 2, (1998), pp. 126–136.
[12] Kazimierczuk MK & Dariusz C, “Quasiresonant and Multiresonant DC-DC Power Converterâ€, in Resonant Power Converters, (2011), pp. 485–558.
[13] Finney SJ, Williams BW & Green TC, “The RCD snubber revisitedâ€, in Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting, Vol. 2, (1993), pp. 1267–1273.
[14] Li RTH, Chung HSH & Sung AKT, “Passive Lossless Snubber for Boost PFC With Minimum Voltage and Current Stressâ€, IEEE Trans. Power Electron., Vol. 25, No. 3, (2010), pp. 602–613.
[15] Smith KM & Smedley KM, “Engineering design of lossless passive soft switching methods for PWM converters. II. With nonminimum voltage stress circuit cellsâ€, IEEE Trans. Power Electron., Vol. 17, No. 6, (2002), pp. 864–873.
[16] Smith KM & Smedley KM, “Engineering design of lossless passive soft switching methods for PWM converters. I. With minimum voltage stress circuit cellsâ€, IEEE Trans. Power Electron., Vol. 16, No. 3, (2001), pp. 336–344.
[17] Wang H, Chen L, Jiang H & He X, “A novel four-level PFC circuit with passive lossless snubberâ€, in 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551), Vol. 2, 2004, pp. 1102–1107.
Downloads
How to Cite
Received date: November 29, 2018
Accepted date: November 29, 2018
Published date: November 30, 2018